Looking after a bush house: moss, lichen and damp
Most houses get a green film somewhere eventually. In west Auckland bush, where rain is heavy and the trees block the sun, the film comes sooner, grows thicker and keeps coming back. It is tempting to treat it as a cosmetic problem and scrub it off each winter. It is more useful to treat it as information: moss and lichen mark places where water stays, and water is what rots and flakes a timber house.
Why it grows where it does
Consumer NZ's exterior walls guidance says moss, mould and lichen are usually caused by damp conditions, leaks, overflowing gutters or trapped water, and that you should fix the source of the dampness first. A Consumer NZ summary also notes that south-facing and wind-exposed walls tend to suffer more damp. BRANZ lists moss and lichen on roofs among common roof problems, typically a sign that regular maintenance has been missed.
On a bush section the contributing factors stack up: overhanging branches drop leaves into gutters, shade slows drying, and the damp air under the canopy keeps surfaces wet well into the day. You cannot change the rainfall, but you can change what happens to the water once it lands.
Start with water, not scrubbing
Before cleaning anything, follow the water. A few checks cover most of it:
- Gutters and downpipes. Consumer NZ advises clearing gutters to prevent overflow and mould. When you clean them, disconnect the downpipe or place a tennis ball or chicken wire over its mouth so debris does not block it, and remove the ball afterwards.
- Ground level. Timber and metal cladding can rot where they touch the ground or paving. Remove soil and plants from the base of walls, consider intercept drains, and make sure paths and landscaping do not send water towards or under the house.
- Holes and gaps. Block holes in cladding that let in water and pests, but do not block the drainage gaps that are part of the cladding system.
- Washed and unwashed surfaces. Rain does not wash areas under eaves or above garage doors, and these are where dirt and growth build up.
Cleaning moss, mould and lichen
Consumer NZ suggests the following for mould: a 1:4 bleach-to-water solution applied with a soft brush and then hosed off with plenty of water, protecting nearby plants with plastic sheeting because bleach can damage them. For moss and black slime, which build up over winter, it suggests water blasting or scrubbing with diluted household bleach, following the instructions on the bottle, letting it dry and then hosing it off. It also advises checking with your cladding manufacturer and hardware store that a product suits your cladding.
For roofs, the Metal Roofing Code of Practice describes a method for lichen: wash the cladding and apply a 2 per cent solution of sodium hypochlorite by low-pressure spray, broom or brush. It cautions that if roof runoff is used for drinking water, you must disconnect the roof outlets before washing any roof or wall cladding with detergents or chemicals. That point matters on a block with a tank, and the water should not go to the tank while you clean.
Some practical rules for a wet climate:
- Work from a safe position. A wet, moss-covered roof is slippery, and roof work is better left to people with proper fall protection.
- Use low pressure on cladding. Hard water-blasting can force water behind boards and strip paint.
- Rinse thoroughly and keep runoff away from garden beds and waterways.
Paint and the exterior
Consumer NZ says cracked or flaking paint is the first sign of paint failure, and that old paint should be sanded or scraped off and bare cladding primed before repainting. Minor chalking, which all paint does over time, does not affect performance but should be removed before repainting. The same source notes that some cladding systems specify a washing frequency to keep the warranty valid, so check the paperwork that came with the house.
A damp bush house tends to need repainting more often than a dry site, because moisture works under the film. The time to repaint is when you see the first cracks and flaking, not after bare timber has been wet through a winter. If the timber has gone soft, the carpentry comes before the paint. Where you want a hand with the work, house painters in Titirangi is a service to look into, particularly for planning a repaint around the wet season.
A yearly rhythm for a bush house
- Late summer: clear gutters of the year's leaf drop, and wash the walls and eaves while it is dry.
- Autumn: before the heavy rain, check downpipes, drains and the ground around the base of the walls.
- Winter: look for new moss, new damp patches, and any ceiling stains after storms.
- Spring: repair and repaint in a dry spell.
A word on timing: paint needs a dry surface and settled weather to cure properly, and in a wet climate those windows are short. If the exterior needs more than a spot repair, Eggshell & Co can help with scheduling and preparation, and it is worth booking ahead of the dry months.
When damp is more than moss
Moss on a shady wall is a surface symptom. Musty smells, soft timber, peeling paint on inside walls, stained ceilings or condensation that does not clear could point to a leak or a failure in the building envelope. Consumer NZ warns that if you leave moisture alone, it moves into the cladding and framing, causing more serious damage. A builder or building inspector can trace the source in a way that painting cannot.