Firewood: seasoning, storing and burning it well
Spring is the time to think about next winter's firewood, which sounds backwards until you have burnt a cold, hissing load of green wood in July. Most lifestyle blocks have a wood burner and a supply of fallen branches, shelterbelt prunings or a trailer load from a neighbour. What you do with that wood between now and May decides whether the fire warms the house or just fills the flue with tar.
Why dry wood matters
Otago Regional Council's guide to better firewood puts it neatly: freshly cut, or green, wood can hold up to 100 percent moisture, which means the water in it weighs as much as the wood. Burn it and most of the energy goes into boiling that water off instead of heating your room. Green wood cools the fire, which produces more smoke and can clog the flue.
Ministry for the Environment guidance on authorised wood burners makes the same point from the air quality side, noting that dry firewood is the most appropriate fuel because it produces less smoke and fewer fine particles.
How long seasoning takes
The Otago guide says green wood takes anywhere from six months to over a year to season, and semi-seasoned wood about six months. Buying wood in spring or summer is generally cheaper, and gives you time to season it yourself. The practical lesson is the same everywhere: you cannot rush it, so the sooner it is cut, split and stacked, the better.
On a block you may be seasoning your own, in which case a stack that sits through a full summer gets through the warmest, driest months. Test it before you trust it, as below.
How to tell it is ready
The same guide gives a checklist you can run on a log before you load the fire:
- It feels much lighter than green wood.
- It no longer smells strongly of wood, since the smell fades as moisture goes.
- The colour has dulled to grey.
- The ends have cracked.
- The bark is gone or comes off easily.
- Two pieces knocked together sound hollow, not with a dull thunk.
- A moisture meter reads under 25 percent. Prongs go into the end of the log, and you wait for the reading.
A moisture meter is the surest check, and the guide notes they are sold at hardware stores. Test a few pieces from the middle of the stack, not just the outside ones.
Stacking and storing on a block
Otago's stacking advice is simple. Choose a dry spot, stack the wood up and off the ground, leave small gaps between pieces for airflow, stack against something for stability (a fence works, with its gaps for extra airflow), and cover the pile to protect it from the weather.
Two things specific to a rural property:
- Fire season. Fire and Emergency New Zealand's rural home fire safety checklist says to store firewood, building materials and other combustible piles away from the house, at least 10 metres during fire season. A woodstack beside the back door is a ready ember trap. Its open-air fire rules also say firewood near a fireplace should be kept in areas unaffected by the fire's heat and away from potential hot ash or embers.
- Storms. Auckland Emergency Management advises bringing inside or tying down anything strong winds could lift when severe weather is forecast, and it names firewood in that list. A loose stack of dry kindling can be scattered across the lawn in a good gale.
Burning it well
Beyond dry wood, keep the flue clean. The Otago guide notes spring is a good time to get it done, and that green wood can clog it. Your burner's manual will describe how to light it and manage the air control.
Fire and Emergency's guidance for permanent fireplaces also asks for a vent or chimney cap, either purpose-built or 5 mm steel mesh, so hot ash and embers cannot escape. On a rural block in summer that is worth having on any chimney.
The burner rules
The rules about which burners can be installed are national, set under the National Environmental Standards for Air Quality. The Ministry for the Environment says the standards for new wood burners apply to those installed from 1 September 2005 on properties under 2 hectares, throughout New Zealand including rural areas. Such a burner must emit less than 1.5 grams of particles per kilogram of dry wood burnt and have a thermal efficiency of at least 65 percent. It must also appear on the authorised list. Open fires, multi-fuel burners, pellet burners and wood-burning cooking stoves fall outside the definition.
The Ministry's frequently asked questions add a rural exemption: a burner that does not meet those standards can still be installed on a property of 2 hectares or more. Moving an existing burner to another spot in the same house counts as a new installation, which means the moved burner must meet the standards and may need a building consent. Modifying an authorised burner can invalidate its authorisation and create safety risks, and the Ministry advises checking with your local council before buying a second-hand burner.
Local rules can add to the national ones, so check Auckland Council's current pages on domestic heating appliances before installing, moving or replacing a burner.
A simple winter plan
- Order or cut wood in spring and split it straight away.
- Stack it off the ground, under cover, with airflow, and 10 metres or more from the house in fire season.
- Test it with a moisture meter before it goes into the house.
- Get the flue cleaned before the first cold snap.
- Fit a cap or 5 mm steel mesh to the chimney before fire season.
Sources
- Otago Regional Council: Better firewood for your home
- Ministry for the Environment: Authorised wood burners, requirements for properties less than two hectares
- Ministry for the Environment: Authorised wood burners FAQs
- FENZ: Rural home fire safety checklist
- FENZ: Open air fire rules
- Auckland Emergency Management: Severe weather